RusticMetalArt has designed a Steampunk Light switch plate.

This auction is only for the single Steampunk Light Switch.

This is Plasma cut and designed to look Industrial with rust, cut marks and possibly scratches and dents. There may be very slight differences in design compared to the photo.

It is all made with 3mm Thick Corten Steel Plate.

NO WIRING NEEDED This will go over your existing switch if your switch is the same as the photo. You can see the before and after photo in the pics.

The only steps you have to do are take out the screws x 2 from your switch. Install the 2 metal 3mm gaskets and then the Steampunk Plate Switch.

Start using. DOWN IS OFF - UP IS ON

NB: If you want to use the switch as a down = on and Up + off, you would have to turn the switch upside down.

For this power must be turned off at the mains, just so you don't stick your fingers into the wiring on the rear while turning around!!! If unsure, your electrician will do it in 2 minutes.

NB: THIS IS MADE TO ORDER, PLEASE ALLOW 4-6 WORKING DAYS PLUS POSTAGE.