TREVOLI UPA 25-150A Booster/Circulation Pump

The Trevoli UPA 25-150 is a large stainless steel circulator pump, designed for water pressure boosting in domestic properties to provide additional pressure to hot and cold water taps and similar outlet points.

The Trevoli UPA 25-150 hot water booster pump can be easily installed to new pipework or existing pipework. The pump increases the water pressure so that the flow rate is comfortably high in showers, taps and any other domestic water outlets. A built-in flow switch starts and stops the pump when the tap is turned on and off- (low flow actuated 2.5-3.0 lpm at 2M Head, this is variable)

When used to boost hot water, the pump will assist in minimising the often annoying change of shower water temperature when someone else at home uses another hot water outlet. Furthermore, there is much less waiting time for hot water to appear in the shower or other water outlet when the hot tap is turned on.

TECHNICAL SPECIFICATIONS

• Power -320W
• 220 - 240V with standard 3 pin plug
• Max Flow rate: 75 L/m
• Max discharge head: 15 metres
• Inlet/Outlet sizes: 25mm / 1" with 20mm/¾" couplings
• Max Fluid temperature range 0 - 110 Deg C
• Max casing pressure: 6 bar
• Enclosure class: IP42
• Winding insulation: Class B
• Distance between inlet and outlet 200mm

Typically adds between 97 kpa and 135 kpa to the existing inlet pressure. The exact amount of pressure added is dependant on the plumbing system, pipe sizes, pipe length etc.

FEATURES

• Very quiet operation
• Low power consumption
• Pump Body- Stainless Steel
• Stainless steel rotor can with ceramic shaft & Seal
• Comes with two Brass Unions (25mm/20mm)
• 1 Year Warranty

Feel free to phone us to discuss your pump and filtration needs. Our phone and contact details can be viewed at: http://www.trademe.co.nz/stores/pumps-online/contact