Timberlywoodturning agent for
Wood- Cut tools
Remember If I cannot break it no one can Wood -Cut Bowl Gouge 10mm "U" shape flute - Un-handled Product Description

Wood-Cut Tools Bowl Gouge 10mm "U" shape flute - Unhandled $66.00 With Handle $98.00

They have been the tool of choice for the majority of turners in New Zealand for many years and are often referred to as their "go to tool".

The big difference with the gouges is the fact that they have replaceable tips and solid shafts.

The benefits are:

The tools are stiffer with almost no flexing especially with the smaller diameter gouges Made from high grade Swedish high speed steel The length of the gouge stays the same The tips are triple tempered thus taking a very keen edge Tips can be replaced for a third of the cost of an equivalent standard gouge They are available handled or un-handled Un-handled tools are supplied with a heavy duty brass ferrule They are sharpened and ready to use The flutes are finely ground and then polished by hand A round shaft is more comfortable in the hand than one with a flute Tip Replacement

To replace a worn out gouge tip, heat the section around the joint with a blow torch for about a minute. This turns the Loctite glue to powder and the old tip can be easily removed, in fact sometimes during the heating process the pops off without any help. Once the shaft has cooled, clean the spigot and flange with a wire brush to remove any glue residue and then with the Loctite ® supplied with the replacement tip fix it to the shaft and leave to stand for at least a couple of hours, preferably overnight and if possible stand it upright. Timberly for the full range of Wood -Cut woodturning tools

The bowl gouges are available in sizes from 10mm, 13mm 16mm and 19mm. Along with replacement tips Introductory Timberly offer Free post anywhere in New Zealand Lathe ,Teknatool