RAM-HOL-UN10-400U RAM® X-Grip® Large Phone Mount with RAM® Snap-Link™ Tough-Claw™

Features

• Small version of the RAM® Tough-Claw™ base is designed to quickly clamp to round, square, and odd-shaped rails and bars ranging from 16-28mm in outer diameter; rubber pads provide stable gripping and protection of mounting surface
• Spring-loaded 'X' design for large phones with rubber caps sports great holding power without hiding your phone; includes optional device tether for peace of mind during rugged use
• Made of high-strength composite and stainless steel hardware for durability and reliability in the most demanding environments
• Backed by a lifetime warranty

This RAM mount has a Snap-link connection which eliminates the arm that most RAM mounts use so it is a low profile solution. Just place the clamp over the rail or post and then tighten with the attached knob - no tools required.

The X-Grip cradle has a clean and clever four leg design that expands and contracts, allowing for a perfect custom fit of your cell phone without hiding your phone behind foam pads and plastic.

The cradle is compatible with hand-held devices that will fit the dimensions listed below. Check the dimensions of your device with a case/sleeve/skin when determining the overall size

Cradle Dimensions

Min Width = 44.45mm / 1.75” – (if min width then min height = 139.7mm / 5.5") Max Width = 114.3mm / 4.5" – (if max width then min height = 82.55mm / 3.25") Max Thickness = 22.2mm / 0.875"

Compatible Devices For a list of many of the compatible devices for this cradle go to our listing for the RAM-HOL-UN10BU

Specs & Features

Clamping Range Rail/Tube Surface: 16mm to 28mm (0.625" to 1.14") Flat Surfaces: 0 to 29mm (0" to 1.14")

Material: High Strength Composite Stainless Steel

YouTube: https://www.youtube.com/watch?v=gSplxuUrtmQ https://www.youtube.com/watch?v=S8ky_uKTw98 https://www.youtube.com/watch?v=rX36fAdknUY