All aluminium box body

Ex streetscape(council street bins) truck. 5mm aluminium sheet. Box body with front lockable compartments both sides, sliding side doors both sides, top hinged rear door (was mounted on a tipper), complete with all lighting and beacon. Both sides have fold down step to access main compartment. Replacement cost in excess of $30,000. Scrap value alone is estimated $2500.Body has been sitting in yard for a few months so hinges etc need lubricating. Rear lower corners were cut off to remove from tipper, but otherwise unchanged from original manufacture. Basic measurements below - if you want other measurements, don't ask - I don't have the time. Inspect it and satisfy yourself as to suitability. Length overall (body, not including protrusions for beacon etc) : 4800mm. Width 2215mm, height1950mm. Front locker doors 1245h x 655w. Side sliders 3580w x 920h. From front of body to front of wheel arch 3460mm. From rear of body to rear of wheel arch 740mm. Rear door 1290mm h. 50mm longitudinal bearers, each spaced 670mm from outside of body.True and straight body, in good condition (hinge lubrication excluded). Apart from streetscaping, this body would suit many uses - food/event truck, mobile mechanic/hose doctor, even some form of camper van. A VERY reasonable reserve has been set - above scrap value but at a level where you can save at least $25,000 from buying new.. NB : All measurements are not guaranteed but will be within 3 or 4 mm of correct. Reasonable questions answered but it is up to you to inspect the body and satisfy yourself. Unit is located in Panmure. Inspection by arrangement Mon - Fri,0800 - 1600 Phone Craig 5728001. Also available to inspect this weekend, ph Murray 027 6434836 (weekend only).