This listing closed and did not sell. The item has been relisted.
- Browse for similar listings in Other
- View the relisted item
Other listings you might like
Description
Transducer 50W 4Ohm - Vibrating the sound of your music
Connect the transducer to an amplifier let it rest somewhere on your body and play your favourite music with it - a most wonderful and different experience of music.
And it's supposed to be heathy too, see here: wakeup-world.com/2016/03/18/7-health-benefits-of-vibroacoustic-sound-vibration-therapy
From the seller's website: The 50 watt VibraSound Vibrotactile Transducer(s) may be mounted to any firm structure you wish to vibrate to music, sound, or vibrations.
You may fasten them with #6 sheet metal screws to most surfaces and you may add double-sided tape for optimum bonding when applied to the underside of horizontal surfaces.
Simply connect speaker wires to the color coded push terminals on the side of each transducer and to the amplified (speaker) output of your stereo receiver amplifier or a independent modular amplifier. It is important to make sure your amplifier is rated to drive a 4 ohm load.
Most audio amplifiers are designed to power 8 ohm loads. You may use an amplifier rated for 8 ohms but it will hold up to continuous use if it is rated to put out at least 75 watts per channel. The transducers can be powered with up to 100 watts each for short duration. As a rule, you will always get a higher quality signal (less distortion) by using a higher power rated amplifier and keeping it’s volume level turned down to a undistorted level.
Details
Shipping & pick-up options
Destination & description | Price | |
---|---|---|
Free shipping within New Zealand | Free | |
Pick-up available from Kapiti, Wellington | Free |
Payment Options
Cash, NZ Bank Deposit