This listing closed and did not sell. The item has been relisted.
- Browse for similar listings in Diffs & axles
- View the relisted item
DIFF BREATHER KIT 5 PORT FORD RANGER PJ/PK ALL MODELS DMA 4x4 DB801/08GR
Description
THE FOLLOWING COMPONENTS ARE SUPPLIED WITH THIS UNIVERSAL KIT
1 X STAINLESS STEEL MOUNTING BRACKET WITH LABEL ATTACHED. TO MOUNTED WITHIN THE ENGINE BAY THAT WILL BE ALWAYS ABOVE THE WATER LEVEL.
2 X GALVANIZED SELF TAPPING SCREWS FOR MOUNTING THE BRACKET.
5 X O-RING SEALED BULKHEAD FITTINGS.
1 X BLACK BULKHEAD BLANK PLUG TO BLOCK OFF THE BASE OF 5th BULKHEAD FITTING IF NOT USED FOR WINCH.
5 X BREATHER / FILTERS
6 X O-RING SEALED WATER-RESISTANT PUSH FITTINGS, Incl Y FITTING.
5 X BRASS HOSE BARBS / Male - For easy connection to existing Factory Breather Hose / Lines if required.
15 X CABLE TIES, UV RESISTANT.
10 X METERS 6MM-OD HOSE.
2 X CORRUGATED PROTECTIVE SLEEVES 1 METER TOTAL COMBINED LENGTH, TO ENCLOSE BREATHER HOSE AT CABLE TIE POINTS IF NEEDED.
1 X INSTALLATION INSTRUCTIONS.
5 YEAR REPLACEMENT WARRANTY.
INSTALLATION TIPS-Due to difficulty in locating Gearbox Transfer case Breather positions on all vehicles this kit is to be installed by a qualified mechanic / workshop that has a hoist with safety equipment available.
Some Transfer Cases, Gearboxs diff housings will not have a Threaded fitting for removal, they will have a Pressed-In Top cover / Hat breather vent installed, in these cases a mechanic must install this kit as they will need to modify the pressed in Top cover / Hat breather to allow rubber hose to be connected and then allowing connection to your diff